Creating a custom M command

ytliu

In order to execute the custom M command, you need to set #108(M Bus IO command response) to 1.

ytliu

By default, G53 is the coordinate system selection command,It does not belong to the motion command group (G0/G1/G2/G3...), it can be used in conjunction with the motion command group. when it is used in conjunction with G0, its motion speed is determined by G0 speed (#80).
The G153 is a motion command group command, which is defined in slib.nc. If the instructions in multiple motion command groups appear on the same line, the last motion instruction that occurs will be executed. For example, G0G153X20Y20 is equivalent to G153X20Y20.

ytliu

The current version does not support it. What keys do you want to use to implement it?

ytliu

Ver:2019-07-18-111 Description:
1. Add M3/M5, M8/M9, M10/M11 hotkeys: ‘1’, ‘2’, ‘3’
2. Increase the toolpath key function configuration, which can be configured as an external output control key.

ytliu

There is no problem with the implementation. Are you sure that this is safe?

ytliu

By extending the keyboard '2' and '3', you can change the M8/M9 and M10/M11 states in any state.

ytliu

Ver:2019-07-23-112 Description:
1. Fixed an error that the file list could not be displayed in the file page without inserting USB stick;
2. Correct the error that the A axis cannot be stopped in the CONT mode in some controllers;
3. M8 / M9 can be manually toggled during "AUTO" via the toolpath key;