The problem of working at low speed

ytliu

Sorry, I don't quite understand.Your question is: is the trajectory incorrect at low speed, or is the intensity of the laser faulty?How do you control your laser?

ytliu

Ok, please upload your configuration file (/ MNT /nand1-1/setting) and nc code.

ytliu

I used this configuration file to run this nc code and found no problems. Which firmware version are you using?
You can install the firmware in the attachment and try.

ytliu

Extract the install directory of the archive to the usb stick, insert the usb stick into the controller, and power it on.

ytliu

You can try to increase the Microstep resolution of the drive and reconfigure # 34-# 36, preferably greater than 400.