Digital Dream Technology support»Forum › DDCS Series Moiton Controller Technology support › DDCSV2.1 - Standalone CNC Motion Controller › The problem of working at low speed

The problem of working at low speed

View number: 10249 | Comments: 10 | Favorite 0

off lights | Prompt: Support keyboard next page<-Left right->

Posts mode

Bpinv

Post Time: 2019-7-5 18:25

Text summary:

Hello. I have the following problem. I use ddcsv2.1 to control the laser. When the cutting speed decreases, the laser starts working incorrectly. Problems begin at speeds below 1000 mm / min and incre ...

Reply

ytliu Posted at 2019-7-8 22:30:24

You can try to increase the Microstep resolution of the drive and reconfigure # 34-# 36, preferably greater than 400.

ytliu Posted at 2019-7-5 22:14:45

Extract the install directory of the archive to the usb stick, insert the usb stick into the controller, and power it on.

Bpinv Posted at 2019-7-5 22:11:44

How I can install the firmware?

Bpinv Posted at 2019-7-5 21:12:52

thank. I will try.

ytliu Posted at 2019-7-5 21:05:22

I used this configuration file to run this nc code and found no problems. Which firmware version are you using?
You can install the firmware in the attachment and try.