|
Thanks a lot for the fast answer!
I just recognize that i somehow messed up M01 and M00 command. I'm sorry for the confusion. Originally, i intented to ask for adding the M00 command, which will stop the GCode programm until the user pushes RUN again.
In my planned setup probably all X1-8 inputs will be in use for other functionalities, so it really would be nice to have the M00 command.
The manual still seems to be the old one, according to the version date on the first page.
It would be nice to have an overview of all used #Paramters. This would help to program e.g. Modbus RTU communication, which is shown in the other topic. And for doing some small calculation inside the gcode you have to know which #Parameters are not in use internally...
Best Regards
Philipp |
|