DDCSV1.1-2.1-3.1 firmware information summary

SDN

Помогите найти последнюю прошивку для DDCS4 V3.1
Спасибо

Devil_Byte

Hi, I was told that ddcsv 2.1 starting from firmware 109 can build a height map. But I couldn't figure out how to do it. Please teach us how to use surface scanning

Devil_Byte

Hi, I was told that ddcsv 2.1 starting from firmware 109 can build a height map. But I couldn't figure out how to do it. Please teach us how to use surface scanning

bolek

Hello all, I have ddcsv2.1 but on-screen say ddcs3v2.1 .I have it unused for a while. The old cutting toy went to the garbage because of the worn and parallel port. I made a new frame and decide to use ddcsv. All works great but don't have all limit switches I use a proximity sw. Working on the proper motor setup I decided to test run circle. Now I see every time the tool gets to the beginning of the circle the machine stop and waits for the controller to catch up. I try different G codes and screw with configuration. Now I know that I have to download  G codes into ddcsv. The problem is that I don't have the imperial measurement, no more, only metric. No matter if I change it in config it shaw in. but the value is in mm.
What did I do, help please

WILEAL

Buenas tardes compre  una controladora DDCS V2.1 la instale inicialmente funciono bien luego dejo de funcionar Z- y no ejecutaba el programa y ahora z+ tampoco funciona hay alguien a quien se le halla presentado este problema que me pueda ayudar

Good afternoon, I bought a DDCS V2.1 controller, I installed it initially, it worked fine, then it stopped working Z- and it didn't run the program and now z+ doesn't work either, is there someone who has had this problem that can help me

WILEAL

Good afternoon, I bought a DDCS V2.1 controller, I installed it initially, it worked fine, then it stopped working Z- and it didn't run the program and now z+ doesn't work either, is there someone who has had this problem that can help me

kankarrio

good morning. I apologize for my level of English, I am using a translator.

I have a ddcsv1.1 3 axis and a ddcsv 2.1 4 axis

What firmware should I install in 1.1 to be able to activate the 4 axes?

c4gcam

Anyone know if  V4.1 firmware is backwards compatible to ddsc V1.1 hardware?

I know the v3.1 (20200306) version works, which I am using on the v1.1.