|
Last edited by Kopf In 2020-2-2 00:08 Editor
Hello,
Once again thanks for your support. The problem I'm having is not with the G28 going back to MACH Z0 but the ABS (work) Z being "re-zero" at the beginning. I thought it was fixed but not, the problem persists after I upgraded with the latest firmware and the same G-Code works with the previous version.
Here the link for the video showing the controller. You'll see the "Z" axis ABS (work position) zeroing in the new firmware.
Firmware 20190804 with G28 - OK
https://youtu.be/wAoYSiLU-SMIt moves to MACH zero and back to ABS work.
Firmware 20190804 without G28 - OK
https://youtu.be/nLaOLObRA8I
Firmware 20200107 with G28 - NOT OK
https://youtu.be/q63IbdBXbQk
It moves to MACH zero, Zero "Z" (second 10 in the video) and back to ABS work.
Firmware 20200107 without G28 - NOT OK
https://youtu.be/jaXjMQXfPyU
I used exactly G-Code from my previous post. For the "without G28" I remove all lines using this command.
Thanks.
|
|