MPG driving the .nc file.

ytliu

you need to set the #3 parameter ("Function of tool path key") to 1, and the "TOOL PATH" key will be used to enter or exit the MPG guidance function.

ytliu

If you want to check the nc code line by line, you can use the single step mode (SBK): in the READY state, press the F4 key, the system enters the single step mode, after which the start key is pressed each time. The code executes one line. Press the F4 key after pressing the Pause key and the system will exit the single step mode.

In order to use the above features, you need to connect the usb keyboard.

With the usb keyboard, you can edit the nc code online.

ytliu

Ver:2019-05-15-109 Description:
1. Increase the coordinate record macro function;(Pending verification)
http://bbs.ddcnc.com/forum.php?m ... tra=page%3D1&page=2
2. Add the macro function GetCenterPos[]: Find the center of the circle through the 3 points on the circle.
GetCenterPos[x1,y1,x2,y2,x3,y3,n1,n2]
x1, y1 is the x-y coordinate of the first point;
x2, y2 are the x-y coordinates of the second point;
x3, y3 are the x-y coordinates of the third point;
n1 is a variable index storing the X coordinate of the center, for example, n1=4, then #4=x coordinate of the center;
n2 is a variable index storing the Y coordinate of the center, for example, n2=5, then #5=y coordinate of the center;
https://www.facebook.com/groups/ ... k/2823155341034952/
3. Increase the all-axis return zero function in the machine coordinate system.
https://www.facebook.com/groups/ ... k/2826643040686182/
4. In the file page, sort by file name
https://www.facebook.com/groups/ ... k/2832029936814159/
5. Change the file editing font and correct the error that the file cannot be edited;

ytliu

In addition, in the single-step mode, sometimes there is no response by pressing the start button, I am looking for the cause of the problem.

If this happens, you don't need to turn off the power, you can press the reset button to exit.

ytliu

Ver:2019-05-16-109 Description:
6. Correct the error that the program stops responding in single-step(SBK) mode;

ytliu

You can modify the eng file and add the #120 parameter to the param page.
#120 -t2 -s1"U disk partition type" -s2"" -m16 -min=0.000 -max=1.000 -i0"With partition" -i1"No partition"

Or force the #120 parameter to 1.
#120=1 -t2 -s1"U disk partition type" -s2"" -m0 -min=0.000 -max=1.000 -i0"With partition" -i1"No partition"

ytliu

Hi Lindo.

I will feedback your question to the forum administrator.