MPG driving the .nc file.

Lindo · Posted at 2019-5-14 13:16:37

Ytliu

Many thanks, I will try this morning.

Best regards

John
Spain

ytliu · Posted at 2019-5-14 06:19:05

If you want to check the nc code line by line, you can use the single step mode (SBK): in the READY state, press the F4 key, the system enters the single step mode, after which the start key is pressed each time. The code executes one line. Press the F4 key after pressing the Pause key and the system will exit the single step mode.

In order to use the above features, you need to connect the usb keyboard.

With the usb keyboard, you can edit the nc code online.

Lindo · Posted at 2019-5-14 02:59:14

ytliu

If I wanted to verify a particular nc type code (programme) looking at each line for line by using the MPG.
What settings on the MPG do I need.
I understand the control will not view the code(programme) IE in reverse but only forwards.
The setting MPG #3 "jog" ? to next line of a code would be very useful when setting up and verifying new programs prior to running using the "RUN" key. less accidents.
I could then alter the through my remote keyboard EDIT the file through the remote keyboard and save back to the USB stick ?
Thanks
John (BARCA) forever
Spain

Lindo · Posted at 2019-4-28 13:19:30

Brilliant

Thanks

John

ytliu · Posted at 2019-4-28 07:49:41

you need to set the #3 parameter ("Function of tool path key") to 1, and the "TOOL PATH" key will be used to enter or exit the MPG guidance function.

MPG driving the .nc file.

View forum before

TEL

0755-87654321