Possible rookie question

ytliu

You can send your G-code to me by email, my email address: liuyt7017@gmail.com

ytliu

I have received your email.
There must be no spaces in the file name;
What do you mean by "does not work well"?Your G-code specifies F as 18000mm/min. Can your machine reach this speed? If it does, you need to adjust the #77, #78, #79 parameters, as these parameters may limit the actual speed.
Since the dimensions of your G-code is small, you can increase the subdivision of the drive to increase the pulse equivalent parameter.

ytliu

You can run your G-code with a small feed rate, such as 3000mm/min.

ytliu

I don't quite understand the meaning of "a miniature Gcode". Can you make a video?

ytliu

You can download it on the 6th floor of this post: http://bbs.ddcnc.com/forum.php?m ... &extra=page%3D1

ytliu

1. Please send me your controller's configuration file (setting, uservar). The way to get them is: enter file page, Switch to '/mnt/nand1-1/' directory, move the cursor to 'setting' ('uservar')file, press 'TAB' key to copy, then Switch to '/udisk-sda1 /' directory and press 'SHIFT' to copy it to the u-disk.
2. Shoot the controller work video.

Then send the above file to me by email.