Possible rookie question

dexpiste · Posted at 2019-4-27 09:42:39

First forgive me for my English
Install this firmware and I have a problem, generate two gcode with .tap extension with the Artcam program, the first one is for roughing and the second Gcode is good but it does not run well, it is executed as if it has very small dimensions but the first Gcode runs well.
Why is this happening?

dexpiste · Posted at 2019-4-27 10:00:28

Maybe I have to configure some parameters

dexpiste · Posted at 2019-4-27 23:07:36

How can I upload a file? I do not know how, I try to paste it but it exceeds the bits

dexpiste · Posted at 2019-4-27 23:13:05

I forgot, before when I had mach3 if it worked well.

dexpiste · Posted at 2019-4-28 04:25:13

Well it still does not work, with what extension do you generate the files for this machine? I generate them as G-code (mm) .tap and only the first file works well, that's if I'm new with this machine.
Can you help me?

dexpiste · Posted at 2019-4-28 09:12:31

Sent, thanks

dexpiste · Posted at 2019-4-28 10:30:12

When I say that it does not work well I mean that my DDCSV2.1 recognizes it but the cnc works as if it were a miniature Gcode.
Now I can not use the cnc but I deduce from your words that if I change the name of the gcode for one without spaces it works right?
The truth is that I am very new in this of the cnc but everything will change, I hope so.

dexpiste · Posted at 2019-4-28 21:52:35

What I mean with Gcode in miniature is that the Gcode is 160 x 160 but when I run it works but the cnc works as if it would be a gcode of 10 x10, a very small Gcode.

dexpiste · Posted at 2019-4-28 22:40:25

It still does not work well, I have tested it without spaces and it works badly in my DDCSV2.1, I think the parameters of my DDCSV2.1 are wrong, there is some manual or some link where I can see how to correctly put the parameters to my DDCSV2.1?

dexpiste · Posted at 2019-4-29 05:48:50

Last edited by dexpiste In 2019-4-29 05:58 Editor

Hello, I already know what the fault is, it turns out that in artcam I configured a new milling cutter and I did not put the correct parameters correctly.
The fact is that now it seems that it is going well and does not perish that the machine loses steps but the cnc is very slow, if I change the parameters it loses steps and I do not know what to do, I have nema 23 76mm motors and tb6600 drivers, you recommend me drivers or is it that I do not really have it properly configured the firmware?

Another thing, the cnc manually moves with vast speed, not too fast but it moves well.

Possible rookie question

TEL

0755-87654321