Possible rookie question

dexpiste · Posted at 2019-4-28 10:30:12

When I say that it does not work well I mean that my DDCSV2.1 recognizes it but the cnc works as if it were a miniature Gcode.
Now I can not use the cnc but I deduce from your words that if I change the name of the gcode for one without spaces it works right?
The truth is that I am very new in this of the cnc but everything will change, I hope so.

ytliu · Posted at 2019-4-28 11:26:49

I don't quite understand the meaning of "a miniature Gcode". Can you make a video?

Lindo · Posted at 2019-4-28 13:31:27

BMPO.jpg
We are the Champions.
Spanish Liga Santander "Barcelona " won the title last night.

First leg 1/4 final champions league versus Liverpool, May 1st. NO problem.

I see you have a new version 2019-04-28-108-xxx , can I ask what has changed.
Do I need to upgrade, if so, please send the instal.zip file

Thanks

John
Spain

ytliu · Posted at 2019-4-28 18:17:37

You can download it on the 6th floor of this post: http://bbs.ddcnc.com/forum.php?m ... &extra=page%3D1

dexpiste · Posted at 2019-4-28 21:52:35

What I mean with Gcode in miniature is that the Gcode is 160 x 160 but when I run it works but the cnc works as if it would be a gcode of 10 x10, a very small Gcode.

dexpiste · Posted at 2019-4-28 22:40:25

It still does not work well, I have tested it without spaces and it works badly in my DDCSV2.1, I think the parameters of my DDCSV2.1 are wrong, there is some manual or some link where I can see how to correctly put the parameters to my DDCSV2.1?

dexpiste · Posted at 2019-4-29 05:48:50

Last edited by dexpiste In 2019-4-29 05:58 Editor

Hello, I already know what the fault is, it turns out that in artcam I configured a new milling cutter and I did not put the correct parameters correctly.
The fact is that now it seems that it is going well and does not perish that the machine loses steps but the cnc is very slow, if I change the parameters it loses steps and I do not know what to do, I have nema 23 76mm motors and tb6600 drivers, you recommend me drivers or is it that I do not really have it properly configured the firmware?

Another thing, the cnc manually moves with vast speed, not too fast but it moves well.

ytliu · Posted at 2019-4-29 07:15:03

1. Please send me your controller's configuration file (setting, uservar). The way to get them is: enter file page, Switch to '/mnt/nand1-1/' directory, move the cursor to 'setting' ('uservar')file, press 'TAB' key to copy, then Switch to '/udisk-sda1 /' directory and press 'SHIFT' to copy it to the u-disk.
2. Shoot the controller work video.

Then send the above file to me by email.

dexpiste · Posted at 2019-4-29 07:34:27

OK, I'll send you an email tomorrow, today it's late in Spain

Possible rookie question

TEL

0755-87654321