DDCSV3.1 software bug fixes

ytliu

In the DDCSV3.1 system, the #116-#119 parameter (zero signal source select) cannot be saved due to an error in identifying the version number, and they are reset to 0 each time it is restarted.

You can download and install the firmware in the attachment to solve this problem.

ytliu

Hi,
I do not quite understand. Can you explain further?
Also, which version of firmware do you need? I can upload it to you.

ytliu

I will add a configuration item to select whether the Z-axis is set to zero when all the axis zeros are performed(shift+'Y-'+'Y-').Is that ok?

ytliu

If you are talking about the Home operation, set it up as described by jjae6.

ytliu

Ver:2019-07-13-111 Description:
1. Add configuration item #2042:whether all-zero op. contains the Z-axis;

ytliu

The installation package provided on the forum is applicable to DDCSV2.1-3.1.
If your controller is DDCSV1.1 and the firmware version number ends with NOR, you can use the installation package in the forum to upgrade.

DDCS three-axis and four-axis applications are the same, and it automatically recognizes hardware information.However, their configuration files (eng,chs,rus) are different. The firmware installation package on the forum uses a 4-axis configuration file, so there is no problem installing it on a three-axis controller.

ytliu

When #2042=1, this firmware will pop up a dialog window during all zero operation.

ytliu

I'm sorry, I misunderstood.I have modified the relevant part in slib.nc, please install it.