|
|
Agree with Richard´s post.
The only clear way I can get to the system files is with a USB " stick in the port".
The only file on the stick is a gcode .nc
But I cannot back out of the "mnt ", I have to power down.
It seems to me to get at the system files for example probe.nc you need to be a very experienced
and computer "savvy". All I want to do is use the controller without any need to
go through this pain of eventually finding the coffee in the tea tin.
There must be a way via a simple 1 or 2 press keys to instantly bring in these system files.
There is no explanations of the verbage mnt ? nand 1 nand 2 etc etc.in the manual.
All I want to be able to do after the parameters are set, clamp a part on my mill, set home positions via a "probe"
set tool heights and enter in the Gcode via a USB stick and cut metal.
I do not want to be a computer engineer at 70 years of age.
Thanks
John
|
|
Posted at 2019-4-16 15:04:02