Different speed with the same code

ytliu

Congratulations on solving the probe problem.
Can you describe this speed difference problem in more detail? It is best to provide the relevant g code and configuration.

ytliu

I can't make accurate judgments about the information you provide. You can check the following items:
1. The speed of G0 is determined by the #80 parameter, not the F programming word;
2. The #125 parameter can affect the speed of G2/G3, such as F=1000mm/min, #125=0.5, then the speed of G2/G3 is F*#125=500mm/min;

ytliu

How is your #6 parameter set? If the #6 parameter is not equal to 3, the system will automatically optimize the speed, you can configure it to 3, turn off the speed optimization function.

ytliu

http://bbs.ddcnc.com/forum.php?m ... &extra=page%3D4

ytliu

You can set the #6 parameter to 3 to turn off the rotary axis speed optimization function.