Probing

gjh

I got it working - the critical item seems to be #223.

ytliu

Thank you, yes, I checked the program and must set #223 to 1 for the probe function to work.

Assolo

Здравствуйте. Подскажите пожалуйста, как можно реализовать второе, уточняющее касание зонда? Сейчас probe выглядит так. Запускаю Probe, ось z опускается до касания датчика и поднимается вверх. Хотелось бы второе касание на медленной подаче. Спасибо.

ytliu

The attached probe will be probed twice, you can customize it by following the prompts in the file and then install it to the controller.

Assolo

ytliu Posted at 2019-10-13 07:10
The attached probe will be probed twice, you can customize it by following the prompts in the file a ...

Спасибо огромное! Все работает!

Garikc

Good afternoon. I have a DDCSV2.1 controller, installed an alternative firmware from Pandora. In PROBE mode, the Z axis does not stop and continues to move forward. Where can I start solving the problem? What parameters need to be checked?

tommygun

Hello, I ordered DDCS V3.1, and I have a probe, which is NC. How can I connect it to the controller? Thanks