What is the future of DDCSv2.1

ytliu

I am sorry for the confusion you have caused.
Probe mode 3 has a description in http://bbs.ddcnc.com/forum.php?m ... page%3D4&page=2, see 13# and 21# for details. In addition, Will_D helped us write the probing manual (here again thanks to his excellent work), you can download it at http://bbs.ddcnc.com/forum.php?m ... amp;extra=page%3D5.

ytliu

You can add the following program to your G code:
M101 (open probed function)
G91 G01 Z-50.0 F500.0 (Z axis moves down 500mm, in this process, if the probe signal appears, the motion will stop)
M102 (turn off the probed function)
G04P0 (synchronous)
G90 G92 Z0.0 (Set the current workpiece coordinate system Z-axis coordinate to 0.0)

In order to use the above features, your version requires Ver: 2018-10-12-102 or later.

ytliu

The attachment is the latest version.
Unzip "install" directory to the root directory of the u disk, then insert the u disk into the controller, then power on the controller, and the system will automatically complete the installation.

ytliu

I am very touched by your attention and understanding. It is the driving force of my work, thank you very much.

ytliu

The general functions are described in the manual. The functions outside the manual are not in the service scope, such as macros. If we add these instructions to the manual, it will increase the service cost.
Some users in the forum put forward the needs, in good faith, in the case that I can do it, try to satisfy, but it does not mean that I have the responsibility to meet these needs.

ytliu

Hi,Lindo.
thank you！
As you can tell, the new version of the Backlash feature has been modified for G2/G3. In the previous version, when the direction of motion changed, a reverse motion code was inserted, which made the motion unsmooth. The current practice is to directly superimpose the compensation amount into the next motion path.

ytliu

Currently DDCS supports usb keyboard and can use wireless keyboard.

ytliu

Hi alexwalex,
Sorry, I forgot, I will fix it today.

ytliu

Ver: 2019-05-28-111 Description:
(2019-05-27-111)
1. Increase G93(inverse time feed rate mode) support.
In inverse time feed rate mode, an F word means the move should be completed in one divided by the F number minutes.
For example, if the F number is 2.0, the move should be completed in half a minute.
http://bbs.ddcnc.com/forum.php?mod=viewthread&tid=62&extra=page%3D1&page=3
(2019-05-28-111)
2. In the inverse screen layout, correct the problem of displaying when switching to M5;

ytliu

Hi Stein.
DDCSV2.1 or 3.1 requires the use of an NPN photoelectric switch.If the axis is deviated during machining, adjust the pulse signal level of the axis (#418-#421)