|
|
Hi!
Just an idea: you can connect the THC outputs to the "START" and "PAUSE" inputs of the contoller and program to files "extkey1.nc" and "extkey2.nc", which do, what you want. The problem mey be, that extkey1/2 -as far as I know- are not performed during G-Code execution.
A more "enhanced" way is to use the Serial Interface of the controller with a microcontroller to get up to 32 input bits and adding some macro calls in your G-code everytime you think it is needed. But this is defenitely the more complicated way...
Josef
|
|
Posted at 2019-2-3 19:00:55