MPG handheld does not work - DDCSE(DDCS-Expert) Professional 5 Axis CNC Motion - Digital Dream Technology support
View: 486|Reply: 2

MPG handheld does not work

[Copy Link]

4

Threads

6

Posts

36

Credits

Newbie Member

Rank: 1

Credits
36
Posted at 2022-3-24 23:56:16 | All floors |Read mode
Last edited by Frans In 2022-3-25 00:11 Editor

I have connected the JMPG45 to The DDCS expert but the alarm button and the axes selector and x1,x10,x100 switches do not work. Can someone tell me which parameters I still need to set for this?
With kind regards Frans
IMG_1905.JPG
Reply

Use props Report

0

Threads

2

Posts

16

Credits

Newbie Member

Rank: 1

Credits
16
Posted at 2022-4-8 19:44:05 | All floors

rm

Last edited by larrylabonte In 2022-4-8 19:45 Editor

I have also a bad MPG direct wiring from the manufacturer.  I have asked for a wiring diagram for it, but it appears that's not an important piece of information. So stuck with a pre-wired controller THAT WAS WIRED WRONG.

Mine causes an alarm to go off immedately and is useless.
Reply Support Opposition

Use props Report

0

Threads

2

Posts

8

Credits

Newbie Member

Rank: 1

Credits
8
Posted at 2022-5-2 18:26:15 | All floors
Last edited by Jero_69 In 2022-5-2 18:34 Editor

I had a similar problem with a different style of MPG but then realised that the Controller needed both power supplies to work. The MPG LED would light with the system power supply but it would not detect the switches and e-stop. When I went to the test page on the DDCSE, I could see the rotary working.

Adding the second power supply bought the rest to life. Buried in the instructions states that you need the IO power supply. The rotary was backwards, but changing parameter #175 fixed that.

There was also the problem where the 5th axis did not work on the MPG. I worked out that the X1 wire was wired where the 5th axis was supposed to be (no X1 on the DDCSE connector). Swapped the wires over (cut the gray wire in the connector and soldered the pink to it) and everything now works great.
2022-05-02 20_29_49-20220501_143015a.jpg
Reply Support Opposition

Use props Report

You need to log in before you can reply Login | Register now

This forum Credits Rules

Shenzhen Digital Dream Numerical Technology Co., Ltd. support
Adress:507,A Building,Leibo Industry Zone,No. 22 Jinxiu East Road,Kengzi Street,Pingshan district,Shenzhen City,P.R. of China
Phone:13244704799
E-mail:info@ddcnc.com

TEL

0755-87654321

Wchat

Website designed by DigitalDream Technology Support
Quick Reply Back to top Back to list