DDCSV3.1 software bug fixes

ytliu · Posted at 2019-4-25 08:27:27

In the DDCSV3.1 system, the #116-#119 parameter (zero signal source select) cannot be saved due to an error in identifying the version number, and they are reset to 0 each time it is restarted.

You can download and install the firmware in the attachment to solve this problem.

Ghost-51 · Posted at 2019-7-12 03:27:08

Hi!!!
Tell me, when sending to 0 - Z also goes to 0, how can I turn it off?
Where can I download the previous firmware version?

thank

ytliu · Posted at 2019-7-12 07:42:49

Hi,
I do not quite understand. Can you explain further?
Also, which version of firmware do you need? I can upload it to you.

Ghost-51 · Posted at 2019-7-12 13:08:19

Installed the latest firmware 4axis (2019-04-25-107)

I do not like that when the team Shift -Y the Z axis also goes to 0
In the first version of the controller this is not, the axis remains at its height

jjae6 · Posted at 2019-7-12 14:28:52

Maybe #54 = 0 (disable Z Home Searching function)?

#54 -t2 -s1"Enable Z Home Searching function" -s3"0:not enable,1:enable" -m8 -min=0.000 -max=1.000 -i0"Disable" -i1"Enable"

ytliu · Posted at 2019-7-12 16:17:34

I will add a configuration item to select whether the Z-axis is set to zero when all the axis zeros are performed(shift+'Y-'+'Y-').Is that ok?

ytliu · Posted at 2019-7-12 16:34:30

If you are talking about the Home operation, set it up as described by jjae6.

Ghost-51 · Posted at 2019-7-13 13:58:19

ytliuI will add a configuration item to select whether the Z-axis is set to zero when all the axis zeros are performed(shift+'Y-'+'Y-').Is that ok?

Well that was such a point

ytliu · Posted at 2019-7-13 16:12:24

Ver:2019-07-13-111 Description:
1. Add configuration item #2042:whether all-zero op. contains the Z-axis;

maxx2000 · Posted at 2019-7-14 00:09:22

ytliu It fits all controllers or 3.1 only.

DDCSV3.1 software bug fixes

TEL

0755-87654321