DDCS V3 Servo Driver Connection

ozkenali

Hello everyone,

I bought a DDCS V3.1 and I have servo driver. I am made connection between DDCS and servo driver but there is no movement on servo motors.

At the attachment you can see my servo driver pin diagram.

I am making connection TB501 connector(main electrical power connections)
Ready and Power leds are flashing. There is no fault led is flashing on servo driver.
And DDCS Step+ step- Dir+ Dir- pins to TB502 connector and there is no movement on motors. What could be the problem?

admin

DDCS V3.1 controller need two power supplies to work properly.One is for controller system one is for IO port.Only when with IO power is supplied,the Input and Output signals,the MPG can have power to work.