DDCSV1.1 4 axis post processor for Aspire

MarioGE

Hi, please help me. What post processor can I use to save my gcode file made with  Aspire to run with my DDCSV1.1??? Thanks

Lukasz

vectric aspire post processor

MarioGE

Lukasz Posted at 2020-3-27 22:36
vectric aspire post processor

Hello Lukasz I try your file but I need to save a file for 4th axis. There is another post processor or there is another way to do it? Thanks a lot.

Lukasz

Hello MarioGE,

Im not sure but I think Aspire supports only three axis. There is a special mode called "wrapping" which enables working with rotary objects (like engraving on cylinders). But in general this mode uses X or Y axis to rotate.
You can easly modify this post processor file, for example to write in gcode "A" instead of "X".
All depends what are your expectations for final generated gcode.

MarioGE

Hello Lukasz thanks a lot.
This is the way that I follow till here but the result is not a great result.
Best regards.