I can't reduce F speed in G code.

yusufçelik

I cannot lower the F speed in the DDCS V3.1 control panel. Since the drill bit I use is at the micron level, I need to use the F speed as 1.8 units when drilling holes. But even though I wrote F1.8 in the G code, it breaks crochet because the F value does not fall below 3 automatically. Please help me with this.

boy_s

Can you solve this problem. Now I have same problem with slowly g-code feedrate. I want to run feedrate 0.02-0.18 mm/min but DDCSV3.1 can show feed at only 1-3 . I test run F0.02 and F0.18 mm/min .Cercle time is same.