After the last firmware, the M6 command stopped working.
The contents of the T.nc file are not executed.
What could be the problem? Delete and copy it again, I already tried.
The settings file is attached to the message.
ytliu Posted at 2018-9-21 21:17
I use the setting file you provided, I did not find the problem you said, I can call T.nc correctly.
I reformatted the flash drive and the problem somehow went away. Then I returned all the files to it, but the problem did not happen again. Probably, the problem was with a flash drive. Thank you for trying.
Posted at 2018-9-21 20:22:08
Favorite
Author
Posted at 2018-9-21 21:17:22