I made a complete list of DDCSV commands, with a description of each setting and examples of applications.
The list was compiled in Russian. The list in English is machine translation.
Please, someone, translate it into English qualitatively.
Ytliu, please see the list. I pointed out all the commands, or is there still?
I would add to this list G93 \ G94. Solves the problem of low speed with simultaneous processing on 4 axes. I checked, even on earlier versions of the firmware, everything worked
Palavan Posted at 2019-6-3 20:17
Prompt stable firmware.
Another question is it possible to start processing with a specific line, as ...
To start a job from a given line, press [2nd/Shift] button, then press [Start] which will ask you what line to start on, use [left/right arrow] to choose the digit and [up/down arrow] to change the digit. When finished, press [Enter/Z-] to start running. If your code is long, it may take minutes to process before cutting. The example I was given says 15 minutes to resume from line 600,000.
Please check the 24V power supply. The DDCS has a power monitoring module. Usually, the external power supply is lower than 18V, and the system will automatically turn off. At this time, the buzzer will beep until you turn off the power.
Hi everyone, I had a problem. During cutting, the controller periodically freezes, makes a long sound and everything goes dead.
what could be the problem?
Hi Lindo,
1. In the video, I used an input on the RS232 IO expansion board as a toggle switch. You can do this with the USB keyboard F11.
2. If your nc code does some cutting, you can set #253 to line mode; if your nc code is an embossed file, you can set #253 to statue mode;
Hello ytliu.
Thank you for notification of future important versions to instal.
I appreciate your consideration.
From you recent video of the MPG driving the g code, I noticed you were
using an external switch.
Is it possible to change parameter #3 from "tool path" to" Try cutting" via the the control buttons.
This way it would not be necessary to change these parameter settings via scrolling down the
numerous pages of settings and manually changing 0 to 1.
Second question from me being a novice, what is the difference between Line mode and Statue Mode parameter setting #253.
Thanks, have a good week.
John
Spain
Posted at 2018-9-13 00:16:09
Favorite
Posted at 2019-6-3 20:20:03