Датчики

Frost

Поддерживает лиCNC Motion Controller DDCS V3.1 датчики PNP NC, как их подключить

DZiK

I'll take a look tomorrow.
The panel supports my positive probe and a negative Z height sensor in one slot without switching settings.
The panel is galvanically isolated, you can just try if it works or not.

In the panel settings, there is definitely a switch from a low signal to a high one.

JessyChen

DDCS V3.1 не поддерживает PNP, поддерживает только тип NPN.
DDCS V3.1 don't support PNP, only support NPN type.