Single Girder Crane Design

taitai

Single Girder Crane main components including: bridge frame, electric hoist, and electric control system. According to single girder crane operation site actual situation, its operation mode can be selected as ground pedant operation, wireless remote operation or driver’s cabin. Single Girder Crane main traveling mechanism adopt soft start motor, smooth and quiet operation, its traveling speed can be designed double speed and frequency control or other types of speed.

Single Girder Crane Bridge Steel Structure Part

Electric Single Girder Crane bridge frame consisted of main girder and end girder. End girder mechanism including traveling motor, reducer, wheel set, rubber buffers and so on.

Single Girder Crane Technical Parameter:

Single Girder Crane Configuration

1. End Beam  2. Driver’s Cabin  3. Main Girder   4. Tonnage Plate  5. Electric Wire rope Hoist  6. Electricity Transmission Device

Single Girder Crane Main Girder

Single girder crane main beam is the main carrier structure; the lower flange is hoist traveling track. Its structure made by steel rolling into U-shaped groove, oblique cover plate, ribs and I-beam welding into plain girder or with steel plate welding into box girder, two ends of the beams set with board connections. Main girder made into upper camber as required, camber degree not less than horizontal level under the rated capacity, main without permanent deformation during normal working.

Single Girder Crane Driving Unit

Single Girder Crane Driving box and cover is cast from good anti-vibration performance gray iron HT200; after aging treatment through special fixture processing and manufacturing on the lathe.

Gears and gear shaft material is 40Cr, after a series of precision machining, heat treatment hardness is 235-269HB.

Single Girder Crane Motor

Single Girder Crane Motor adopt soft start motor, to achieve start from slow speed to normal speed finally reach stability; which solved impact operation compared to the normal motor and applicable to frequent start, energy saving and environmental protection situation. Standard Motor insulation class is B, protection class IP44, also can made to F, H insulation class, IP54, IP55 protection class according to working condition requires.

Single Girder Crane Wheel Set

Single Girder Crane Wheel set made of 45 # steel, made after precision machining and heat treatment, heat treatment hardness 300-380HB, hardened layer not less than 260HB at a depth of 15mm.

Single Girder Crane Electrical generally use Mitsubishi, Yaskawa, Siemens, Schneider and related brands.

Single Girder Crane Electrical Protection Systems

Single Girder Crane Emergency power-off switch

Single Girder Crane set with red mushroom head type rotary reset emergency power off switch for emergency situations quickly cut off main power and control circuit of the single girder crane. Emergency power off switch mounted in the place convenient for worker operation.

Single Girder Crane Overload Limiter

When Single Girder Crane load reaches 90% of its rated load, single girder crane overload limiter issued suggestive alarm signal; when the load reaches 110% of its rated load, single girder crane limit switch immediately cut off the lifting power source and issued prohibitive alarm signal.

Single Girder Crane Travel limit

• Single Girder Crane Lifting mechanism equipped with up and down fire stopper, as the limit switch of lifting mechanism, it also has protective effect against the controller adhesions.
• Single Girder Crane travel limit including common limit switch, and higher performance, smaller size, more accurate limit space photoelectric switch or laser anti-collision device.
  

Single Girder Crane Design