|
|
Last edited by Domenico_Ita In 2020-1-19 14:01 Editor
Hello everyone,
I am mounting the DDCS4 v3.1 in a 6040 with MKS-V-04 controller. I'm almost done but I can't understand how to mount the controls that operate the spindle. I have a Nowforever E100 inverter, on the old controller I have two sets of black-red-yellow cables that connect the controller with the inverter.
The pins on inverter are:
That are connected with controller as picture below
How i must connect the cable on DDCS4 ?
Thank you very much for anyone wants help me 
This is my Control Box when finish.. I must to execute te square hole for USB input and repaint the cover.
|
-
2.jpg
(461.39 KB, Down times: 721)
-
1.jpg
(577 KB, Down times: 652)
-
3.jpg
(576.43 KB, Down times: 687)
-
2.jpg
(461.39 KB, Down times: 691)
-
1.jpg
(577 KB, Down times: 657)
-
4.jpg
(461.07 KB, Down times: 697)
|
Posted at 2020-1-19 13:58:45
Favorite