Last edited by Kwood94xj In 2019-5-30 19:57 Editor
Hello everyone,
I bought an OMIO X6-2200L CNC a while ago with the Mach3 control card. I hate Mach3 as I have a background with real CNC Controllers. Anyway it came with a small wireless remote like the one in the Link Below. I bought a V2.1 a while ago and I am just now getting it converted. My question is does the current Firmware support a remote like this over USB? Thank you for your time and all the effort you put into this system Yt Liu!
Last edited by yaddatrance In 2019-6-8 07:34 Editor
Lindo, the DEL key on the main keyboard (not number pad) unmounts the usb stick... I haven't tried but the 'F10' and Numpad's '*' acts like the mode key normally (which is used to delete files in the file tab) so I would use caution pressing those keys in the file tab.
ESC homes to the main page or selects values in parameters, and does not unmount disks.
Also note that the Number pad's Delete key zeros an axis.
Hi yaddatrance，
Thank you for the information provided. For the problems encountered with wireless MPG, I think it may be caused by the lag of the driver response under Windows.
Since this wireless MPG cannot be connected to DDCS, I recently tried to simulate wireless MPG using the wireless mouse wheel to verify responsiveness.
Hi Lindo,
display showed nothing other than "nan",This is caused by /mnt/nand1-1/setting corruption, which should be independent of the use of a USB hub. The reason for the configuration file corruption may be that the power is turned off immediately after the configuration is completed, causing the settings file not to be properly stored.
Posted at 2019-5-30 19:55:24
Favorite
Posted at 2019-6-7 15:46:06
