DDCSV3.1 software bug fixes

ytliu · Posted at 2019-4-25 08:27:27

In the DDCSV3.1 system, the #116-#119 parameter (zero signal source select) cannot be saved due to an error in identifying the version number, and they are reset to 0 each time it is restarted.

You can download and install the firmware in the attachment to solve this problem.

Ghost-51 · Posted at 2019-7-23 01:54:29

Last edited by Ghost-51 In 2019-7-23 01:56 Editor

Thanks, it works as it should.But there are bugs, I will observe - I will unsubscribe

ytliu · Posted at 2019-7-16 05:38:26

I'm sorry, I misunderstood.I have modified the relevant part in slib.nc, please install it.

Ghost-51 · Posted at 2019-7-16 01:54:47

Last edited by Ghost-51 In 2019-7-16 02:13 Editor

Install the firmware, # 2042 = 1 или 0, Z axis goes to 0Video https://yadi.sk/i/zWj8n7tO_fLS-Q

Ghost-51 · Posted at 2019-7-14 11:44:08

Thank you, we will install and proto-process on Monday

ytliu · Posted at 2019-7-14 10:32:18

When #2042=1, this firmware will pop up a dialog window during all zero operation.

ytliu · Posted at 2019-7-14 06:19:15

The installation package provided on the forum is applicable to DDCSV2.1-3.1.
If your controller is DDCSV1.1 and the firmware version number ends with NOR, you can use the installation package in the forum to upgrade.

DDCS three-axis and four-axis applications are the same, and it automatically recognizes hardware information.However, their configuration files (eng,chs,rus) are different. The firmware installation package on the forum uses a 4-axis configuration file, so there is no problem installing it on a three-axis controller.

Ghost-51 · Posted at 2019-7-14 01:43:00

Ghost-51 · Posted at 2019-7-14 00:52:48

ytliu Ver:2019-07-13-111 Description:
1. Add configuration item #2042:whether all-zero op. contains the Z-axis;

Thank you, have not yet installed.
Is it for 4 axis controller?
It may be better to add a paragraph in the menu and leave it as it was in previous versions (Shift + 2 * -X), is there such an opportunity?

ytliu · Posted at 2019-7-13 16:12:24

Ver:2019-07-13-111 Description:
1. Add configuration item #2042:whether all-zero op. contains the Z-axis;

Ghost-51 · Posted at 2019-7-13 13:58:19

ytliuI will add a configuration item to select whether the Z-axis is set to zero when all the axis zeros are performed(shift+'Y-'+'Y-').Is that ok?

Well that was such a point

DDCSV3.1 software bug fixes

TEL

0755-87654321