Title: cannot set pulses per unit [Print This Page] Author: Oupajohn Time: 2022-1-15 20:12 Title: cannot set pulses per unit I cannot set the pulses per unit. On Mach3 the setting for my machine is 13.3 pulses per mm, but DDCS allows a minimum of 50. The result is that my steppers run 4x further than they should. How to fix this??
I should be able to configure for imperial units (inch) but I have not worked with inches since 1960. Author: AndreyB Time: 2022-1-17 13:48
Parameter 39
#39 A axis pulse unit 0=pulse/deg,1=pulse/circle
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)