Digital Dream Technology support

Title: DDCSV2.1 is not working properly [Print This Page]

Author: tahanm Time: 2018-11-7 14:56
Title: DDCSV2.1 is not working properly
My DDCSV2.1 does not work properly.
I am working with g90 absolute coordinates.
The g0 command destroys the program so I am using g1 instead.
The command g2/3 works only with r. With i,j it gives wrong radius.
While running quit long program after correctly finishing the first pocket I am moving z axis to 5mm it goes there but desides tha it is hiz new 0 and does not doing the second pocket since it engraving in the air.
Please advice
Best Regards
Meir

Author: ytliu Time: 2018-11-7 16:50
Please provide your settings and GCode files.

Get setting file: Go to the /mnt/nand1-1/ directory, move the cursor to setting file, press the TAB key to copy, then go to the /udisk-sda1/ directory and press SHIFT to copy it to the u disk.

Author: tahanm Time: 2018-11-9 01:17

ytliu Posted at 2018-11-7 16:50
Please provide your settings and GCode files.

Get setting file: Go to the /mnt/nand1-1/ directory, ...

I did not understand the directions you sent
where are /mnt/nand1-1 and what is U disk?
Best Regards
Meir

Author: tahanm Time: 2018-11-9 01:37

ytliu Posted at 2018-11-7 16:50
Please provide your settings and GCode files.

Get setting file: Go to the /mnt/nand1-1/ directory, ...

OK I figured it.
How to attach a file to send you the gcode and the setting
Best Regards
Meir

Author: ytliu Time: 2018-11-9 07:04
Compress them and upload them to the forum.

Author: tahanm Time: 2018-11-9 15:33
I couldn't figure out how to upload the compressed file to the form.
The is no upload button or menu
Best Regards
Meir

Author: 71taa Time: 2018-11-9 16:14
Switch to "High mode" (right corner of the reply form).

Author: tahanm Time: 2018-11-9 23:44
HiIt does not allow ZIP file or the setting file
Please send me your mail and I will send it directly to you
Best Regards
Meir

Author: ytliu Time: 2018-11-10 07:02
liuyt7017@gmail.com

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)