Title: DDCS3.1 plasmacutter fusion 360 post processor [Print This Page] Author: Teebot Time: 2021-10-13 03:19 Title: DDCS3.1 plasmacutter fusion 360 post processor Last edited by Teebot In 2021-10-13 03:27 Editor
I designed and completed my plasma cutter with floating Z head, I connect the float switch to probe and Gnd I use M3/M5 to fire the plasma.
I need help with a postprocessor for fusion-360 that add probing command and M3/M5.
What settings and configuration must I make in the controller also?
Author: babisgr Time: 2022-4-28 23:34
for spindle (plasma torch in your case) controll there is nothing else...m3 fire the plasma now,its the standard for spindle start/stopAuthor: misael Time: 2022-10-23 00:45
voce conseguiu?Author: misael Time: 2022-10-23 00:45
você conseguiu, porque preciso da mesma resposta sua
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
