Title: Ability to disable "safe height of Z axis" parameter #82 [Print This Page] Author: math_indy Time: 2018-10-5 23:57 Title: Ability to disable "safe height of Z axis" parameter #82 Parameter #82 "safe height of Z axis" returns the Z-axis to the specified height at the beginning of every program cycle. I would like the ability to disable this feature as it is undesirable in some situations especially when using programs that use G91 "incremental".
I have parameter #82 set to "0" but this is not the same as "disabling parameter #82" because the Z-axis still returns to Z0.0 at the beginning of every program. For example, in the program below I want it to incrementally remove 0.001" from a surface every time it runs (Z-0.001, Z-0.002, Z-0.003,.. etc.) .
If, because of parameter #82 the DDCSV2.1 always returns to Z0.0 at start then my use of G91 to incrementally lower the Z-Axis by -0.001 every cycle means it never decends below -0.001.
Author: ytliu Time: 2018-10-6 06:23
If you want to turn off this feature, you can empty the contents of safez.nc in the installation package and install it to the controller.Author: math_indy Time: 2018-10-9 03:16
I removed the M98 P101 that was inside the safez.nc file and, as you said, this fixes the issue for me.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
