Title: how to use tool offsets? [Print This Page] Author: ghall Time: 2021-7-9 04:14 Title: how to use tool offsets? g code T1 does not select tool 1. How do you get it to use the tool offset table?Author: weitling Time: 2021-7-31 14:02
I have the same problem I think that the M6 T2 is calling the subrutine TC.NC but that is in chinese and is not been running when i call tool change with M6. If i use the TAB button and go to T0 and i try change to T1 it just ignore it and return to T0 Author: Ivan_Britt Time: 2021-9-2 21:46
Для использования компенсации длины и радиуса нужно применять нужный код (G43 и номер ячейки компенсации), прописывается в управляющей программе. Почитайте инструкцию, там всё написано.Author: AdaDDream Time: 2021-9-13 14:23
Hope this could help you
