Title: Modify go up z axis [Print This Page] Author: Xartan Time: 2021-1-10 07:32 Title: Modify go up z axis Last edited by Xartan In 2021-1-10 07:33 Editor
Hello
I have a 3.1 panel.
When I execute a gcode in the panel 3.1, the Z axis, goes up 40mm and then goes back down to the start position of the job correctly.
My question is...
- Is it possible to modify it so that it does not go up to 40mm and that it goes up to 20mm the Z axis at the beginning of the job?
DDCSV3. 2DDREAM
SEE: 2019-09-18-112NOR
Thank you Author: ShaniaDDream Time: 2021-3-15 14:09
Please check #82 ( page 66), whether you have set the value here 40mm, perhaps you can change it to 20mm. You can try it first .
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)