Title: expert slave axis? [Print This Page] Author: kemenlos Time: 2020-10-26 22:06 Title: expert slave axis? This controller (expert) does support slave axis? Author: JessyChen Time: 2020-10-27 09:15 Last edited by JessyChen In 2020-10-27 09:17 Editor
Hi friend, No, don't support Slave axis.You can wire doube Y axis drivers to Y terminal of the Expert controller.Author: kemenlos Time: 2020-10-29 22:41
You make me sad with this answer dear, tandem motor setup and slave function for both motors and drivers in same axis is very important feature.
Thank you.Author: JessyChen Time: 2020-10-30 15:06
Hi Dear Sir, yes, you are right. For many customers the dual Y axis is very important. So we will add this features asap.
Thank you so much of the advise. Author: kemenlos Time: 2020-11-4 17:17
You're welcome!Author: Levi Time: 2020-11-16 23:33
Hello friend, do you have a time frame on when this will be available ?
I am holding off buying this controller until slave becomes a feature. Any information will be helpful.Author: CJFAugusto Time: 2021-1-4 18:37
Bom dia, este controlador já suporta o eixo escravo?Author: CJFAugusto Time: 2021-1-4 18:41
Bom dia,
Já resolveram o problema do eixo escravo? Author: garypclaus Time: 2021-1-19 23:20
Have you updated the software to support a slave axis yet?Author: Casusbelli Time: 2022-4-7 16:32
The last firmware update allow to use slave axis function but still missing squaring function with 2 sensors...
Slave axis without dual sensor seems useless but let's hope the next update will bring that option !
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
