Title: DDCS v3.1 with 2 motors of Y axes [Print This Page] Author: milcho43 Time: 2023-11-13 04:33 Title: DDCS v3.1 with 2 motors of Y axes I bought DDCS v.3.1 controller and my machine has 2 motors for Y axes.
My question is:
Can I take signal from Y axes from the controller and connect parallel 2 drivers of 2 motors?
I mean YP+, YP-, YD+,YD- from the controller to connect with Pul+, Pul-, Dir+, Dir- of each of the drivers.
In forums some people share they use 2 relays but I do not know how to connect . How the coil of each relay takes automatically power...
Other people use MASTER / SLAVE connection.
Other people use synchronization board SEN SYNC v1.3s but this product is not available in the market anymore.
Please help me. I cannot find enough info.Author: Quadfather331 Time: 2023-11-22 04:15
I have the same setup on my machine. I ran one signal wire from the controller to one of the Y1 stepper drivers and then just added a jumper wire to the other Y2 stepper driver from the other one. Seems to work fine for me. Author: Tyo Time: 2023-11-23 15:07
I just bought ddcs V4.1....I'm having problems connecting the vfd inverter to ddcs...which one should I connect...inverter vfd yl620-A
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)