Title: DDCS v4.1 Error 05 help [Print This Page] Author: bryn7jones Time: 2023-11-9 04:44 Title: DDCS v4.1 Error 05 help Hi all! I have recently built a CNC with the DDCS v4.1 controller. I keep receiving the same error on the Z-axis servo driver (HBS57H Servo): Er05. This stalls the Z-axis but does not shut down the process so X and Y and spindle continue with toolpaths.
Any ideas what is causing this? It is happening after roughly the same amount of time on each run.
Thanks in advance.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)