Digital Dream Technology support

Title: Run, checking, and then freezes at first G0 line... [Print This Page]

Author: mecmag Time: 2018-4-26 15:22
Title: Run, checking, and then freezes at first G0 line...
Hello,
I have been using the controller normally for over a month and last week it stops to work.
The manual movements (with arrow keys) works normally.
But when i launch the program, it checks, starts, and freezes when sees the first G0 line. (no movement is made while in play auto)

The code is correct because the same file worked already 10 days ago and i did not change it.

Also, all my new generated files are not working anymore....

is there any suggestions? should i reinstall the firmware? (by the way, i do not have it... someone knows where to download it?)
maybe i deleted some important file in the controller?? (actually it is empty)

thanks

Author: rb3rnardi Time: 2018-5-4 03:38
Hi. Did you solve it ? I'm having the same problem. thanks

Author: ytliu Time: 2018-5-4 06:22
Hello！
The attachment is the latest firmware installation package. After the installation is complete, the parameters will be restored to the factory settings.

install(2018-04-12-93).zip

562.15 KB, Down times: 590

Author: 71taa Time: 2018-5-4 21:38

ytliu Posted at 2018-5-4 06:22
Hello！
The attachment is the latest firmware installation package. After the installation is comple ...

Hi, ytliu! Thanks for your support, learned alot about advanced capabilities of the controller from your posts.
As I can see it is a newer build compared to 92. It would be great to hear about latest changes, if possible.
Thanks again!

Author: supergoldfish Time: 2018-5-6 11:58
Not sure if this would solve your problem.. But I have also occasionally noticed this behaviour. I can't run G-Code on first power up. Everything works after either a probe cycle, or zero z. Seems like there is a lockout feature to prevent running and possible crash without doing this first?

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)