Title: DDCSV1.1 4 axis post processor for Aspire [Print This Page] Author: MarioGE Time: 2020-3-27 19:23 Title: DDCSV1.1 4 axis post processor for Aspire Hi, please help me. What post processor can I use to save my gcode file made with Aspire to run with my DDCSV1.1??? ThanksAuthor: Lukasz Time: 2020-3-27 22:36
vectric aspire post processor
Hello Lukasz I try your file but I need to save a file for 4th axis. There is another post processor or there is another way to do it? Thanks a lot. Author: Lukasz Time: 2020-3-28 19:48
Hello MarioGE,
Im not sure but I think Aspire supports only three axis. There is a special mode called "wrapping" which enables working with rotary objects (like engraving on cylinders). But in general this mode uses X or Y axis to rotate.
You can easly modify this post processor file, for example to write in gcode "A" instead of "X".
All depends what are your expectations for final generated gcode.Author: MarioGE Time: 2020-3-31 22:33
Hello Lukasz thanks a lot.
This is the way that I follow till here but the result is not a great result.
Best regards.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
