Digital Dream Technology support

Title: Help to connect Nowforever E100 to DDCS4 V3.1 [Print This Page]

Author: Domenico_Ita Time: 2020-1-19 13:58
Title: Help to connect Nowforever E100 to DDCS4 V3.1
Last edited by Domenico_Ita In 2020-1-19 14:01 Editor

Hello everyone,
I am mounting the DDCS4 v3.1 in a 6040 with MKS-V-04 controller. I'm almost done but I can't understand how to mount the controls that operate the spindle. I have a Nowforever E100 inverter, on the old controller I have two sets of black-red-yellow cables that connect the controller with the inverter.

The pins on inverter are:

That are connected with controller as picture below

How i must connect the cable on DDCS4 ?

Thank you very much for anyone wants help me

This is my Control Box when finish.. I must to execute te square hole for USB input and repaint the cover.

2.jpg (461.39 KB, Down times: 247)

1.jpg (577 KB, Down times: 233)

3.jpg (576.43 KB, Down times: 238)

2.jpg (461.39 KB, Down times: 237)

1.jpg (577 KB, Down times: 240)

4.jpg (461.07 KB, Down times: 233)

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)