Digital Dream Technology support

Title: External Key 1 Find Middle [Print This Page]

Author: denverh Time: 2019-6-8 06:07
Title: External Key 1 Find Middle
Hello,

I've set #446 = 1, and I was hoping it would divide the active MPG axis value by 2. However, if I set one axis to 1.0000, then activate that input, the value for that axis changes to 12.7000. I'm using inches (#115 = 1), so perhaps this function is not taking that setting into account? Or does "find middle" do something else?

I'm currently using firmware 2018-10-09 on a DDCSV2.1.

Regards,

Denver

Author: ytliu Time: 2019-6-8 06:58
Thanks for your feedback, I will check the program today.

Author: ytliu Time: 2019-6-8 14:21
Ver: 2019-06-08-111 Description:
11. Correcting the error of find middle function in inch mode(#115=1).

install(2019-06-08-111).zip

608.44 KB, Down times: 501

Author: denverh Time: 2019-6-9 02:50
Ok, that works fine now. Thank you so much for your help.

Denver

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)