Title: Do the Z0 [Print This Page] Author: Eric Time: 2022-10-5 19:25 Title: Do the Z0 Hello, on a DDCSV4.1 (it must be identical for a V3.1) I use a 3d sensor to make my 0.
The tool is 162.56mm in position H01. When I do a Z0 I always have to deduct 162.56 so that the Z0 is correct from one tool to another. Is there a solution to not enter this value every time when doing the Z0? Is there a setting that automatically fills the box?
In the SysDisk there is a "zeroz" file, inside there is the parameter #1508=0, what is it?
Thanks in advance
Author: Alex469 Time: 2022-10-7 14:34
Unfortunately, there is no system variables description for DDCS controller. I have made some research and found that the following system variables contains current workspace coordinate for corresponding axis:
#1506 - X-axis
#1507 - Y-axis
#1508 - Z-axis
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)