Ddcsv3.1 on LATHE ???

gmillwater

I'm so frustrated because my code does exactly what it's supposed to do on any axis EXCEPT the Z axis. What gives. G0 is slow no matter the settings. And when you restart the code, it reverses and runs back to 0 then forward again!  And on a lathe, the Z axis is the carriage. ANYONE know whats going on with this $250 controller thats absolutely useless for a lathe????

AdaDDream

Sorry, DDCS V3.1 can not using on lathe.

AndreyB

What gives. G0 is slow no matter the settings

Whats speed?
Show all your "Autmatic control parameters"

And when you restart the code, it reverses and runs back to 0 then forward again!

Try delete /mnt/nand1-1/safez.nc

Sorry, DDCS V3.1 can not using on lathe.

Why "DDCS V3.1 Users Manual" mentions lathes?