|
|
Last edited by Miklo In 2024-5-26 15:03 Editor
HiI installed a laser on my CNC.
It is connected to the VSO and GND pins of my DDCSV2.1.
Unfortunately, it stays on all the time while burning.
What are the settings in "Spindle parameter" in the DDcs so that the laser turns on and off depending on the Gcode?
Or if you also installed a laser, what are your settings in "Spindle parameter"?
Thank you so much for your help.
(Sorry for the translate)
|
|
Posted at 2024-5-12 02:10:14
Favorite