Can the DDSC v3.1 controller work with a lathe?

alexdpol

Hello.
Bought a DDSC v3.1 controller for my lathe. Now there is the latest firmware (2020-03-06-112NOR).

I can't figure out how to do the thread, etc.
You may need to install a special firmware or configure it somehow, please help me figure it out.

Thank you in advance.

JessyChen

DDCS V3.1 cannot do the lathe job.

JessyChen

DDCS V3.1 cannot do the lathe job. DDCS-Expert can do, you can configure one axis to servo spindle, easy.

jorge1969

Hi,can the ddSc v3.1 run a small plasma table