DDSC-Expert Standalone Motion Controller (5 axis) -- starting

amen20065

we power on the screen simply displays "starting" and never changes
Same issue - it just displays "starting'. How do we rest and get past this please?

amen20065

Good day to all! When loading, it constantly resets and does not load! This happened after I connected the keyboard! How to reset it?

amen20065

Good day to all! When loading, it constantly resets and does not load! This happened after I connected the keyboard! How to reset it?

amen20065

V1.zip

The store with Ali Express "Shop910724082 Store" helped me
he sent me a file with the V1 firmware version (V1.zip) by email

1: Copy the install folder to an empty USB drive
2: Insert the USB drive, restart the system and wait for it to automatically start up;

I downloaded the install folder to a flash drive and inserted it into the USB slot, after rebooting everything became ok

http://www.ddcnc.com/?m=home& ... tid=101&lang=en
(maybe he took it from here)

Hi, My friend
Welcome to my shop, what can I do for you?
You can leave me a message or contact me by
My Email: kkcnc888@163.com
My WeChat ID：L941124924
My WhatsApp ID：+86 18320919675
If you need to order in large quantities, please leave your email ID or Whatsapp ID for contact, or you can find me through the above contact information.
Have a good day.