Problem running some gcode

ddcsv_user

Hi, new member hopefully you can help me with some "Teething" problems.

I have a DDSCV 2.1, I use Fusion 360 to generate my Gcode.

When I load this code on the DDSCV it does nothing, it flashes busy for a second and then reads ready.

A few pieces of code I generated have done the same thing or fired a syntax message at me.

Some code does work that I upload.


I have the post processor set as Fanuc.

Any help is greatly appreciated, included generated gcode.

ddcsv_user

ddcsv_user

I read the post processor thread and turned helical moves off in the fanuc processor and removed o1001 and code worked.