|
|
DDCSV2.1, when booting shows 4.1.
When I HOME X and Z they go home correctly, 1) fast in the sensor direction, 2) stop, 3) slow CREEP off the switch. This is correct behaviours on all machines..
But Y is not like this at all. Immediately upon press Y HOME It starts to CREEP in the wrong direction, never stops. If it hits the wall the steps continiues!
I tried reversing Y, set soft limit in different places - doesn't matter.
Out side of that Y WORKS OK ALSO IN A PROGRAM.
Please help. Thanks.
|
|
Posted at 2019-12-19 23:37:24
Favorite