DDCSV3.1 A axis configuration problem

KVIEW

I have added and configured a rotary A axis with the following settings.
Stepper Motor is 1.8 deg, ratio is 6:1, and the micro steps are set to 8
I calculated it to be 26.667 pulse/deg and it is accurate enough, but the
problem is getting it to rotate faster. Rotation speed is about 1 full 360 per hour.

I have been threw the setting and manual, but have not found any solution to
the problem. Please let me know if I missed something.

AndreyB

1) You dont say, whats parameters you try change.
2) Try
#44
#103
#77
#80

KVIEW

Thanks for your reply, I did check those values and they were good,
but at some point I must have lowered #48 setting. I reset it to default
and now everything is working. Thanks...